Spirent C1 - Spirent C1 and C2 Admin Commands (Continued)

Spirent C1 and C2 Installation Instructions
Using Authenticate Mode (optional)
34 | Spirent C1 and C2 Installation Instructions
PN 71-008959 Rev A April 2020
ping6 <ipv6address> Ping an IPv6 address
ptp Display or change the ptp settings
reboot Reboot the system
recovery <chassis|tm> <enable|disable> Enable or disable appliance or test module recovery (Test
Module Recovery is not supported on all test modules)
resetnetwork Reset all network settings to the factory defaults
restartsysmgr Restart system manager
securemode [on|off] Enable or disable secure mode
serialno Show the appliance serial number
shutdown Shut down the system
status Show the status summary
switch_version Switches to the standby partition and reboots the system
standby_version Displays the version of the standby partition (non-active)
version Display the current version
Table 7. Spirent C1 and C2 Admin Commands (continued)
Command Description