Dismantling Instructions
15
P. DRUM ASSEMBLY
1. Remove the top cover as in (A)
2. Remove the control panel as in (B)
3. Remove the front panel as in (G)
4. Remove the right hand panel to make drum
removal easier.
5. Remove the two screws that secure the
rear bearing cover.
6. Remove the screw securing the bearing.
7. Remove the drive pin.
8. Remove the rear bearing.
9. Pull the drum clear of the rear panel and
remove.
Q. MOTOR
1. Remove the right hand side panel as in (F).
2. Remove the 8 screws that secure the heat-
er cover.
3. Remove the 3 hex screws that secure the
two fans to the motor shaft.
NOTE: The inner and outer fans
are Different. Ensure the fans are
reassembled in the correct order.
Continued on next page
To Next Page
Loading...
