>>>
Before using your washer for the rst time, run a ‘Clean Washer’ cycle (see back page)
.
Using your new Splendide washer is easy!
Press ON.
The symbols on the display will light.
Load the drum. Be sure the laundry
has been sorted by fabric color/type
and all pockets are empty.
Load the dispenser (See left).
Select a wash cycle. The optimal spin
and temperature settings for that cycle
will be shown on the display.
Use buttons to customize the cycle.
Any spin and temperature settings you
modify will be saved and preselected
the next time this cycle is used.
Laundry Aid
Dispenser
Press and HOLD the START button
for 2 seconds, then release it. A BEEP
will indicate the cycle is accepted.
NOTE: Your washer uses state-of-the-art
safety and performance technologies.
Water will enter the drum AFTER
certain load criteria have been
measured and met (up to 2 minutes).
To pause the cycle tap the START/
PAUSE button once. To unpause, press
and hold 2 seconds, then release.
To cancel the cycle Press and hold the
ON/OFF button. The cycle will stop, any
water will drain, and the machine will
shut off.
WASHER QUICK GUIDE
QR-W
WFL1300XD
1
2
3
DISPLAY
M
AX
1
2
4
3
A
B
SlowCold
Hot
Spin+
Drain
Wash Rinse
Fast
Chamber 1:
Prewash detergent* (powder
ONLY)
Chamber 2:
Powder or liquid HE
detergent* (Move plastic
partition to slot A when using
liquid or store in slot B when
using powder.)
Chamber 3:
1-2 Tbsp. fabric softener
Extra Chamber 4:
Bleach
IMPORTANT!
*Use only High
Efciency (HE)
detergent in the correct
dosage for your
machine (1-2 TBSP of
powder detergent (or
liquid equiv.) per load.
1
Laundry Aid Dispenser
Display
Super
Wash
Post Cycle
Care
Extra
Rinse
Delay
Start
Spin
Speed
Temp.
Press & HOLD
2 seconds
,
then release
SEE BACK PAGE FOR ‘CLEAN WASHER’ AND ‘WINTERIZATION’ INSTRUCTIONS > > >
Pre
Wash
To Next Page
Need help?
General
