Splendide WD2100XC User Manual

210 oX
C
Contents
General information, 1-2-3-4-5
Technical Information, 2-3
For your safety, 4
Introduction, 5
Installation requirements, 6-7
Attention / Grounding instructions, 6
Electrical, location and draining, 7
Installing the washer-dryer, 8-9-10-11
Unpacking the washer-dryer, 8
Removing the transit screws, 8
Connecting the water inlets, 9
Connecting the drain hose, 9
Installing the exhaust ducting, 10
Leveling the washer-dryer, 10
Completing the installation, 11
About your appliance, 12-13-14-15
Washer-dryer special features, 12
Control panel, 13
Option buttons, 14
Program key, 14
Detergent and laundry aids, 15
Dispenser drawer, 15
Washing and drying, 16-17-18-19
Cycle Description Chart, 16
Before starting a cycle, 17
Determining load sizes, 17
Setting a ‘wash’, ‘dry’ or ‘wash-to-dry’ cycle, 17
Splendide laundry tips, 18
For best results, 18
Combo laundry FAQ’s / Sample loads, 19
Care and maintenance, 20-21
Turning off the water or electricity supply, 20
Cleaning the dispenser drawer, 20
Checking the water inlet hoses, 20
Cleaning the pump pre-chamber, 21
Checking the dryer vent, 21
No lint filter to clean, 21
Troubleshooting, 22-23
Troubleshooting Chart, 22
If you need assistance, 23

Splendide WD2100XC Specifications

General

Type	Washer/Dryer Combo
Energy Star Certified	No
Ventilation	Vented
Width	23.5 inches
Voltage	120 V
Spin Speed	1200 RPM

Summary

Safety Precautions and Warnings

General Safety Instructions

Lists essential safety instructions for operation and maintenance.

Flammable and Hazardous Substances

Warns against flammable solvents, storage, and hydrogen gas.

Electrical Safety Procedures

Instructs on disconnecting power and avoiding electrical shock.

Installation Requirements and Warnings

Pre-Installation Safety Checks

Emphasizes reading instructions and safety warnings before installation.

Installation Surface and Grounding

Details carpet installation hazards and grounding instructions.

Electrical Shock Hazard

General warning about electrical shock during servicing.

Installing the Washer-Dryer: Unpacking and Connections

Unpacking and Initial Inspection

Removing Transit Screws

Crucial step to remove shipping screws before operation.

Connecting Water Inlet Hoses

Guide on connecting water hoses to supply taps and machine.

Connecting the Drain Hose

Standpipe Drain System Installation

Details standpipe requirements for draining.

Sink Drainpipe System Connection

Explains how to connect the drain hose to a sink drain.

Installing Exhaust Ducting and Leveling

Exhaust Venting Restrictions and Materials

Prohibits improper venting and specifies ducting material.

Ducting Installation Best Practices

Cabinet Door Airflow Requirements

Leveling the Washer-Dryer

Starting and Operating Cycles

Pre-Cycle Checklist

Setting a Wash-to-Dry Cycle

Step-by-step instructions for combined wash and dry operations.

Setting a Wash-Only Cycle

Instructions for setting up a wash-only cycle.

Setting a Dry-Only Cycle

Instructions for setting up a dry-only cycle.

Laundry Tips and Best Practices

Drying Safety Warnings

Alerts about hot doors, flammable solvents, and foam rubber.

Care and Maintenance Procedures

Power Supply and Cleaning Preparation

Water Inlet Hose Inspection

Exterior and Drum Cleaning

Dispenser Drawer Cleaning

Odor Prevention

Specific Maintenance Tasks

Cleaning the Pump Pre-Chamber

Lint Filter and Dryer Vent Check

Troubleshooting Common Problems

Appliance Not Starting or Filling

Lists causes and solutions for power, start, and water fill issues.

Filling/Emptying and Drain/Spin Issues

Troubleshoots continuous fill/empty, drain, and spin failures.

Vibration, Leaks, and Fault Codes

Addresses excessive vibration, leaks, and diagnostic mode indicators.

Advanced Troubleshooting and Support

Foam, Dryer Start, and Drying Performance

Obtaining Technical Assistance

Provides contact information for technical support and service.