Pressing the measuring key (6) switches on the instru-
ment.
Set up and measuring modes are selected with the ar-
row keys (5).
Measuring is started automatically whenever the internal
probe is pressed in. When using external probes, meas-
uring is started manually by pressing the measuring key
(6) while in the Bearing mode.
The blue measuring LED (9) stops blinking when an SPM
measuring cycle is completed.
The green, yellow and red LEDs (4) beside the display
indicate the bearing condition after an SPM measure-
ment.
If not used, the instrument will automatically shut off
after 2 minutes. It can also be shut off by simultaneously
pressing the LEFT and RIGHT arrow keys.
When switched back on, the instrument will resume its
last mode.
Start up
1
3
4
7 9
2
5
6
8
Serial number and software version
To check which software version is in your instrument
and find out the instrument serial number, go to the
Main display. Press the DOWN arrow key to enter the
General Settings mode. Use LEFT/RIGHT arrow keys
to highlight the Information icon (i), then press the UP
arrow key to see the software version and serial number.
To return to the General Settings mode, press the LEFT
arrow key.
To return to the Main display, use LEFT/RIGHT arrow
keys to highlight the Return icon, then press the UP
arrow key.
General
settings
Software version
and serial number
Back/Return
Main display
To Next Page
Loading...