Instruction Manual
Machine Condition Tester T30
Contents
Measuring with Machine Condition Tester T30 ..................3
Basic, Logger and Expert versions
.....................................1
Functions in manual and data logger mode
.......................2
Instrument layout, screen and keys
....................................3
Instrument layout, inputs
....................................................4
General setup
......................................................................5
Batteries
..............................................................................6
EPROM and memory
..........................................................7
Time and display light
.........................................................8
Manual measuring mode
....................................................9
Record keeping and measuring intervals
.........................10
Follow-up form, example
..................................................11
SPM measuring points
......................................................12
Shock pulse transducer with probe
..................................13
Transducer with quick connector, terminal
.......................14
Measuring points, examples
.............................................15
Measuring points, examples
.............................................16
SPM - shock pulse measurement
......................................17
The dBm/dBc technique
...................................................18
Normalized and unnormalized readings
...........................19
Input data
.........................................................................20
SPM measurement
...........................................................21
Peak indicator and earphone
............................................22
Different shock pulse patterns
.........................................23
General remarks on system planning
...............................24
Measuring range
...............................................................25
Create acceptable measuring conditions
........................26
Experience before full scale monitoring
...........................27
Communication and cooperation needed
........................28
Measuring intervals
...........................................................29
Machine units and measuring rounds
...............................30
Evaluation, why and when
................................................31
Verify the reading
..............................................................32
Identify the shock pulse source
........................................33
Typical shock pulse patterns from rolling bearings
..........34
Irregular measuring results
...............................................37
Confirming bearing damage
.............................................38
Unnormalized readings on gear boxes
.............................39
General remarks on machine vibration
.............................42
Measuring vibration
..........................................................43
Definition of machine classes according to ISO
...............44
Measuring points and transducers for VIB
.......................45
Setting vibration transducer sensitivity
............................46
Vibration severity measurement
.......................................47
Follow-up on vibration readings
.......................................48
Fault analysis chart
............................................................49
Recording a vibration spectrum [Expert]..........................50
Measuring speed
..............................................................51
Measuring temperature
....................................................52
Data logging, general procedure [Logger, Expert]..........53
Measuring rounds in Condmaster®Pro [Logger, Expert] 54
Data logging – measuring sequence [Logger, Expert] ....55
Displays in data logging mode [Logger, Expert] .............56
Setting comments [Logger, Expert] .................................57
Multiple SPM results [Logger, Expert] .............................58
Alternative measurements, setup [Logger, Expert] .........59
Entering alternative measurements [Logger, Expert] ......60
Check points [Logger, Expert]..........................................61
Long-time recording, program setup [Logger, Expert] ...62
Long-time recording, measurement [Logger, Expert] .....63
Identification tag CondIDTM
............................................64
Transferring the measuring point data to the tag
...........65
Testing ID tags and clearing the instrument memory
......66
Identification tag CondIDTM in Condmaster®Pro
...........67
Passwords for identification tags
......................................68
Balancing single - plane rotors ...........................................69
SPM Instrument AB • Box 504 • SE-645 25 Strängnäs • Sweden
Technical data are subject to change without notice.
Tel +46 152 225 00 • Fax +46 152 15075 • info@spminstrument.se • www.spminstrument.com ISO9001 certified.
© Copyright SPM 2010-03. 71650.B
To Next Page
Need help?
General
