Technical data are subject to change without notice.
© Copyright SPM 2002-04. 71650.B
SPM Instrument AB • Box 504 • S-645 25 Strängnäs • Sweden
Tel +46 152 225 00 • Fax +46 152 15075 • info@spminstrument.se • www.spminstrument.se
Basic, Logger and Expert versions
Machine Condition Tester T30 is available in three different versions: Basic, Logger and Expert.
”Basic” measures vibration severity, shock pulses, speed and temperature. It has no data logging
functions – measuring results are recorded manually. It can be set to continuous measurement but
does not record the results shown on the display.
”Logger” measures the same quantities. In connection with the SPM software Condmaster
®
Pro, it
gets its measuring instructions from a PC and uploads measuring results via cable to the PC. Thus,
this version can also be loaded with comments and checkpoints as well as instructions for
continuous recording of vibration, shock pulses, speed and temperature.
”Expert” has all the logger features. In addition, it uses the EVAM
®
method for vibration spectrum
display and vibration analysis.
A ”Basic” version can be upgraded to ”Logger” and ”Expert”.
Shock pulse, dBm/dBc
Vibration severity, ISO 10816
Temperature measurement
Speed, contact and optical
Continuous reading
Data logging with Condmaster
®
Pro
Measuring point identification with CondID
TM
Two alternative measuring systems
Selectable comments
Display of check points
Long time recording
Vibration spectrum
Evaluated vibration analysis
Measuring techniques
and other features
Tester T30
123
Basic Logger Expert
•••
•••
•••
•••
•••
••
••
••
••
••
••
•
•
General description, setup 1
To Next Page
Loading...
