SPM T30 - Measuring Rounds in Condmaster Pro [Logger, Expert]

Technical data are subject to change without notice.
© Copyright SPM 2002-04. 71650.B
SPM Instrument AB • Box 504 • S-645 25 Strängnäs • Sweden
Tel +46 152 225 00 • Fax +46 152 15075 • info@spminstrument.se • www.spminstrument.se
Measuring rounds in Condmaster
®
Pro [Logger, Expert]
The purpose of rounds is to:
• to group together a number of machines and measuring points which are to be measured at
the same time with a hand-held instrument. For data loggers, you must have either rounds or
work orders to be able to load the instrument.
• to define the measuring sequence by listing the points in a certain order.
• to simplify planning of periodic work by setting time intervals for its execution.
• to simplify measurements on machines with variable speed. If the rpm of a group of bearings
is dependent on the variable speed of the process, as in a paper machine, a single data input
at the time of measurement or reporting will adjust the speed data of all bearings in the
round.
You can mix all measuring techniques handled by the instrument.
You must be careful with SPM measuring points where the rpm i a) measured or b) pre-set prior to
measuring shock pulses. Points with measured speed are put into separate rounds. Constant and
pre-set speed can be mixed, but you can input only one pre-set speed per round.
For each round, you set a first execution date. The next execution date is set automatically, by
adding the set time interval to the date the round is reported and closed. Depending on the
working mode you choose in Condmaster
®
Pro, you work with one round at a time (Data Transfer)
or with work orders containing several (Planning). You can mix rounds with different speed types in
a work order.
Valid measuring rounds, SPM:
measured speed only
constant speed only
pre-set speed (1)
constant speed +
pre-set speed (1)
Measuring rounds
• Mix all measuring techniques
• For SPM, do not mix uncompatible speed types
Data transfer
One round
at a time
Planning
Several rounds
in one work
order. Max. 10
rounds with
different
preset speeds.
M
C
P
C + P
any
M
C
P
C + P
54 Data logging