Technical data are subject to change without notice.
© Copyright SPM 2002-04. 71650.B
SPM Instrument AB • Box 504 • S-645 25 Strängnäs • Sweden
Tel +46 152 225 00 • Fax +46 152 15075 • info@spminstrument.se • www.spminstrument.se
62 Long-time recording
Long-time recording, program setup [Logger, Expert]
Long-time recording implies that you can measure continuously on one measuring point, simulta-
neously using one, two, or three transducers: SPM + VIB + RPM, or SPM + VIB + TEMP. Speed
and temperature cannot be measured together because the probes use the same input connector.
The measuring instructions are set up in Condmaster
®
Pro, function RECORDING. You make a
recording set containing one or more measuring points. After each input, you see how much
memory is left for additional points. You input:
• the measuring point.
• the measuring technique(s) to be used.
• the time interval between readings, 0 to 60 minutes.
0 = no pause between readings. The instrument will collect data as fast as it can. If the
measuring time is set to e.g. 5 minutes, the instrument will measure all selected parameters
once, switch to stand-by for the rest of the 5 minutes, then start the next reading.
• the total number of readings to be taken. The theoretical maximum is 9999.
Measuring point
dBm/dBc
No. of measurements
20
5
Save
Cancel
Help
None
Temp
Rpm
Evam
VibV
VibH
SPM
Temp/Rpm
Vibration
Techniques
Time between measurem.
F-100.01
To Next Page
Loading...
