Technical data are subject to change without notice.
© Copyright SPM 2002-04. 71650.B
SPM Instrument AB • Box 504 • S-645 25 Strängnäs • Sweden
Tel +46 152 225 00 • Fax +46 152 15075 • info@spminstrument.se • www.spminstrument.se
Long-time recording, measurement [Logger, Expert]
As always in data logger mode, you start with a display of measuring point number and name, plus
measuring technique used: REC = long-time recording. Connect the transducers/probes and press
ENT (parameters are shown), then the M key to start.
An X before the measuring technique marks the measurement in progress. Readings are saved
continuously. If you interrupt with ENT before the total is reached, you can either upload the
uncompleted recording to Condmaster
®
Pro or repeat the measurement, starting again with
reading 1.
Selected points can be measured in any order. To save battery, the instrument powers down when
the total is reached. If the batteries should become exhausted, the memory back-up will preserve
you measuring results.
Long-time
recording
Parameters:
Measuring point
Measuring technique(s)
Time interval
Total no. of readings
Limiting factors:
Instrument memory
Battery life
Long-time recording
Parameters
Cancel
ENT
AT30.200.04
Exhaust fan 6
fan N
REC 001
AT30.200.04
SPM VIB TEMP
Interval 5 min
Total 20
Measuring
Exit,
next
ENT
AT30.200.04
X SPM VIB TEMP
Reading 7
Total 20
M
ENT
Long-time recording 63
To Next Page
Loading...
