Date d'émission : Janvier, 2019 Révision: 2 Page : 38/60
Problem Possible cause Solution
The auger is creating
noise as it rotates
• The bell shaped shaft seal has been
replaced without lubrication or is
damaged
• The auger has been incompletely or
incorrectly reassembled
• Replace or clean and lubricate with the
lubricant provided with the machine
• Check and correct
The CUT OUT light on
the right side panel is on
• The filter is dirty and needs to be
cleaned
• The unit is positioned too close to a
wall or other object restricting air
flow and causing the machine to
run at a higher temperature
• The filter is not properly installed
• The unit has been installed near a
heat source, such as a coffee
machine, ice maker or cold
beverage machine which expels hot
air from its vents, causing the
machine to run at a high
temperature.
• Clean and replace filter following
instructions
• Reposition unit to maximize ventilation
space (see installation figures)
• Properly install filter see
• Reposition unit to maximize ventilation
space (see installation figures)
To Next Page
Loading...
