Edition: October, 2018 Revision: 2 Pag. : 35/76
10. MECHANICAL CONTROL BOARD
a) Activate the general switch (D);
b) Each bowl is controlled by two switches which
are activated as follows:
- to make ice slush or sorbets: first select the
switch (1) (L for left bowl, C for the central one
and R for the right one) to activate the mixer
components, then select the corresponding
switch (2) to activate the cooling system in the
freeze mode.
- in order to activate the defrost mode: select
the switch (1) (L for left bowl, C for the central
one and R for the right one) to activate the
mixer components, then select the
corresponding switch (L) to activate the cooling
system at a positive temperature.
c) The (E) switch controls the covers’ LED lights.
!CAUTION!
IPRO is equipped with an insulated bowl
that will preserve the product temperature
for many hours so once it will be necessary
to operate in defrost/chill mode, we
recommend to extend the duration of this
operating mode until the product complete
melting.
! Warning !
If the machine is turned off at night, with the
bowls filled, or just partially filled, a layer of
solid ice may form on the surface, due to the
natural separation of the unmixed product. In
this case, before turning the machine back on, it
is necessary to verify for the product complete
melting in order to prevent damage to the
mixing auger.
To Next Page
Loading...
Need help?
General