Data di emissione: December, 2013 Revisione: 1 Pag. : 46/68
6. POSITIONING
FOR MAINTENANCE WORKER ONLY
The installation and subsequent servicing
operations must be carried out by skilled
members who have been trained to use the
device and in compliance with the
regulations in force.
a) Remove the packing (fig.1) and preserve it
in order to reuse for winter storage.
Caution
All the parts of the packaging must be kept
beyond the range of children, as they might
represent a potential safety/health risk.
b) Make sure the machine is in perfect
condition.
b) Rest the machine on a sturdy, horizontal
surface making sure it is well ventilated by
leaving a gap of 20 cm around it and do not
install it near heat sources (fig.2); we
recommend you to maintain a room
temperature between 24 and 30°C.
c) Check that the power mains voltage meets
the specifications on the equipment
identification plate and that the output available
meets the device’s power requirements.
Fit the plug into an earthed socket, removing all
multiple adaptors.
FOR FURTHER PRECAUTIONS, READ THE
SECTION “CONNECTION TO THE ELECTRICITY
MAINS” CAREFULLY.
d) The installation must be carried out in
accordance with the manufacturer’s instructions.
Failure to comply with the positioning and
installation instructions may impair the
machine’s operation.
Important
You are legally required to provide a suitable
grounding system for the equipment.
Before carrying out any cleaning and/or special
maintenance on the device, make sure it is
disconnected from the mains by unplugging it.
In the event of a breakdown or malfunctioning,
switch off the device and remove the plug.
Fig. 1
Fig. 2
To Next Page
Loading...
Need help?
General
