Springfield 91455 - Temperature Alert Configuration; Countdown Timer Usage; System Reset Procedure

Setting the Temperature Alerts
You can program your weather center to sound an alert whenever the indoor or outdoor temperature
exceeds the upper or lower pre-set level. The outdoor alert can be set for all remote channels.
Setting the Indoor Temperature Alert
 Press and hold the ALERT button for 3-4 seconds. The high temperature limit icon and indoor
temperature will be flashing.
 Press UP or DOWN to select the high temperature alert level.
 Press ALERT and the low temperature limit icon and temperature will be flashing.
 Press UP or DOWN to select the low temperature alert level.
 Press ALERT to return to normal mode.
 Press ALERT to activate or de-activate the alert function. When the alert function is activated, both
the high and low limit icons will show.
Setting the Outdoor Temperature Alert
 Press and hold the ALERT button for 3-4 seconds.
 Press CHANNEL to select the channel on which you want to set the alert. (1 to 3)
 The high temperature limit icon and outdoor temperature for the channel you selected will be
flashing.
 Press UP or DOWN to select the high temperature alert level.
 Press ALERT and the low temperature limit icon and temperature will be flashing.
 Press UP or DOWN to select the low temperature alert level.
 Press ALERT to return to normal mode.
 Press ALERT to activate or de-activate the alert function. When the alert function is activated, both
the high and low limit icons will show.
Using the Countdown Timer
 In the normal display mode, press MODE 3 times to display the countdown timer. TIMER will show
on the display.
 Press the SET button for 3-4 seconds and the hour will be flashing.
 Press UP or DOWN to set the hour.
 Press SET and the minutes will be flashing.
 Press UP or DOWN to set the minutes.
 Press SET and the seconds will be flashing.
 Press UP or DOWN to set the seconds.
 Press SET to lock in the time.
 Press SET to start the countdown timer.
 As the timer is counting down you can press SET to pause. Press SET again to re-start the timer.
 After the timer reaches -00- and the alarm sounds, press any button on the front of the base station to
silence the alert. The LCD display will revert to the normal time display.
 If you want to clear or re-set the timer before the countdown reaches -0-, pause the countdown and
enter the new countdown time using the above procedure.
RESET
Your multi-zone thermometer can be re-set in case of malfunction. Press the RESET button once and the
unit will return to its original factory settings. Re-enter your settings according to the OPERATING
INSTRUCTIONS.