Installation Instructions
PRE-TEST CHECK LIST
Review this list after installation to avoid charges for a
service call that is not covered by your warranty.
• Check to be sure power is OFF.
• Open door and remove all foam and paper packaging.
• Locate the owner’s manual in the literature package.
• Read the owner’s manual for operating instruction.
• Check door opening and closing. If door does not open
close freely or tends to fall, check spring adjustment.
• Check to be sure that wiring is secure under the
dishwasher, not pinched or in contact with door
springs or other components.
• Check door alignment with tub. If door hits the tub,
level the dishwasher.
• Pull lower rack out, about half way. Check to be sure
it does not roll back or forward on the door. If the rack
moves, adjust leveling legs.
• Check door alignment with cabinet. If door hits cabinet,
reposition dishwasher.
• Check that door spring does not contact water line,
fill hose, wiring or other components.
• Verify water supply and drain lines are not kinked or
in contact with other components. Contact with motor
or dishwasher frame could cause noise.
• Add 1.5 quarts of water to the bottom of the dishwasher
to lubricate the pump seal.
• Turn on water supply. Check for leaks. Tighten
connections if needed.
9
LITERATURE
Be sure to leave complete literature package and
installation instructions with the consumer
DISHWASHER WET TEST
• Turn on power supply(or plug power cord into outlet,
if equipped).
• Start with normal wash.
• Check to be sure that water enters the dishwasher.
If water does not enter the dishwasher, check to be sure
that water and power supply are turned on.
• Check for leaks under the dishwasher. If leak is found,
turn power supply off, then tighten connections. Turn
on power again after leak is corrected
• Check for leaks around the door. A leak around the door
could be caused by door rubbing or hitting against
adjacent cabinetry. Reposition the dishwasher if necessary.
• Check drain lines when draining. If leaks are found, turn
power off and correct as necessary.
• After the unit drains, open the door and make sure most
of the water has drained. If not, check that disposer plug
has been removed and/or air gap is not plugged.
• Let dishwasher turn through another fill and drain cycle.
Check again for leaks and correct as required.
REPLACE TOEKICK
Align toe kick along the bottom edge - make sure it
is against the floor. Replace the two screws.
.
Figure 28
To Previous Page
Loading...
