What to do if the SPX FLOW Measuring Instruments actuator doesn't work and air escapes?
If the actuator of your SPX FLOW Measuring Instruments isn't working and air is constantly escaping from the venting plug, the suggested solution is to replace the complete actuator.
How to fix an untight valve in SPX FLOW Measuring Instruments?
If the valve in your SPX FLOW Measuring Instruments is untight, replace the seat seals and check the line pressure against the permissible line pressure specified in chapter 9.
What to do if there is leakage in the clamp area of SPX FLOW Measuring Instruments?
If you notice leakage in the clamp area of your SPX FLOW Measuring Instruments, the recommended solution is to replace the housing seals.
How to repair leakage at the upper shaft in the yoke area of SPX FLOW Measuring Instruments?
If there's leakage at the upper shaft in the yoke area of your SPX FLOW Measuring Instruments, you should replace the shaft seal, seat seal, and guide bushing.
Details essential safety precautions, hazards, and procedures to prevent injury or damage.
Details closing times, valve stroke, air consumption, and product pressures for various configurations.
Provides step-by-step instructions for dismantling and assembling single seat valves.
Covers maintenance, seal replacement, and assembly procedures for the actuator.
Details dismantling and assembly procedures specific to the change-over valve configuration.
Lists common valve and actuator failures with their corresponding remedies.
General| Brand | SPX FLOW |
|---|---|
| Model | APV DELTA SW4 |
| Category | Measuring Instruments |
| Language | English |
To Next Page