Waukesha Cherry-Burrell Brand W60/W80 Valves Introduction
08/2018 95-03022 Page 9
Introduction
For control top information, please refer to publication 95-03083.
For additional product information, please see our website at
www.spxflow.com/en/waukesha-cherry-burrell/resources/
product-literature.
General Information Information in this manual should be read by all personnel
involved in installation, setup, operation and maintenance of
W60/W80 valves.
Always use installation tools and lubricants recommended by
SPX FLOW. Waukesha Cherry-Burrell brand products are
subject to intensive intermediate and final leakage and functional
tests.
W60/W80 Series valves meet 3-A and EHEDG standards for
sanitation, design and style.
Factory Inspection Each Waukesha Cherry-Burrell brand valve is shipped
completely assembled, lubricated and ready for use.
Models and Specifications Materials
Product Wetted: ASTM 316L
(UNS-S31603); (DIN-1.4404)
Non-Product: ASTM 304
(UNS-S30400); (DIN-1.4301)
Seat Material: Tef-Flow
™
(standard)
Tef-Flow
™
P (optional)
Tri Ring (optional)
Metal (optional)
Bonded (optional)
Elastomers: FKM (standard)
EPDM (optional)
Equipment Serial Number Waukesha Cherry-Burrell brand valves are identified by a serial
number found on the label on the actuator cylinder.
To Next Page
Loading...
Need help?
General
