SRAM BlipBox - Adhesive Mounting Procedures

11
Install
Einbauen
Instalación
Installer
Installare
Monteren
Instalar
Adhesive Adhesive Adhesive
Adhesive Adhesive Adhesive
Adhesive Adhesive Adhesive
Attach the adhesive tab to the back
of the flat or curved puck mount and
remove the paper backing.
Attach the adhesive tab to the back
of the flat or curved puck mount and
remove the paper backing.
Attach the adhesive tab to the back
of the flat or curved puck mount and
remove the paper backing.
Attach the adhesive tab to the back
of the flat or curved puck mount and
remove the paper backing.
Attach the adhesive tab to the back
of the flat or curved puck mount and
remove the paper backing.
Attach the adhesive tab to the back
of the flat or curved puck mount and
remove the paper backing.
Attach the adhesive tab to the back
of the flat or curved puck mount and
remove the paper backing.
Attach the adhesive tab to the back
of the flat or curved puck mount and
remove the paper backing.
Attach the adhesive tab to the back
of the flat or curved puck mount and
remove the paper backing.
Position the mount in the desired
location and press down to attach.
NOTICE
Clean the stem surface with isopropyl
alcohol before attaching the mount.
Position the mount in the desired
location and press down to attach.
NOTICE
Clean the stem surface with isopropyl
alcohol before attaching the mount.
Position the mount in the desired
location and press down to attach.
NOTICE
Clean the stem surface with isopropyl
alcohol before attaching the mount.
Position the mount in the desired
location and press down to attach.
NOTICE
Clean the stem surface with isopropyl
alcohol before attaching the mount.
Position the mount in the desired
location and press down to attach.
NOTICE
Clean the stem surface with isopropyl
alcohol before attaching the mount.
Position the mount in the desired
location and press down to attach.
NOTICE
Clean the stem surface with isopropyl
alcohol before attaching the mount.
Position the mount in the desired
location and press down to attach.
NOTICE
Clean the stem surface with isopropyl
alcohol before attaching the mount.
Position the mount in the desired
location and press down to attach.
NOTICE
Clean the stem surface with isopropyl
alcohol before attaching the mount.
Position the mount in the desired
location and press down to attach.
NOTICE
Clean the stem surface with isopropyl
alcohol before attaching the mount.
Remove Retirer Retirar
Entfernen Rimuovere
取り外し
Quitar Verwijderen
拆卸
1
2
3