SRAM BlipBox - Wiring and System Configuration; Blip Wire Installation and Routing

15
Installation Installation Installation
Installation Installation Installation
Installation Installation Installation
NOTICE
Measure the length of wire required
and select the appropriate Blip wire
length before installing the Blip.
To avoid damage to wires, avoid
sharp bends.
Secure wires to the handlebar with
electrical tape.
Secure any loose wires together.
Wrap bar tape over the wires.
It is ok to wrap bar tape over Blips.
NOTICE
Measure the length of wire required
and select the appropriate Blip wire
length before installing the Blip.
To avoid damage to wires, avoid
sharp bends.
Secure wires to the handlebar with
electrical tape.
Secure any loose wires together.
Wrap bar tape over the wires.
It is ok to wrap bar tape over Blips.
NOTICE
Measure the length of wire required
and select the appropriate Blip wire
length before installing the Blip.
To avoid damage to wires, avoid
sharp bends.
Secure wires to the handlebar with
electrical tape.
Secure any loose wires together.
Wrap bar tape over the wires.
It is ok to wrap bar tape over Blips.
NOTICE
Measure the length of wire required
and select the appropriate Blip wire
length before installing the Blip.
To avoid damage to wires, avoid
sharp bends.
Secure wires to the handlebar with
electrical tape.
Secure any loose wires together.
Wrap bar tape over the wires.
It is ok to wrap bar tape over Blips.
NOTICE
Measure the length of wire required
and select the appropriate Blip wire
length before installing the Blip.
To avoid damage to wires, avoid
sharp bends.
Secure wires to the handlebar with
electrical tape.
Secure any loose wires together.
Wrap bar tape over the wires.
It is ok to wrap bar tape over Blips.
NOTICE
Measure the length of wire required
and select the appropriate Blip wire
length before installing the Blip.
To avoid damage to wires, avoid
sharp bends.
Secure wires to the handlebar with
electrical tape.
Secure any loose wires together.
Wrap bar tape over the wires.
It is ok to wrap bar tape over Blips.
NOTICE
Measure the length of wire required
and select the appropriate Blip wire
length before installing the Blip.
To avoid damage to wires, avoid
sharp bends.
Secure wires to the handlebar with
electrical tape.
Secure any loose wires together.
Wrap bar tape over the wires.
It is ok to wrap bar tape over Blips.
NOTICE
Measure the length of wire required
and select the appropriate Blip wire
length before installing the Blip.
To avoid damage to wires, avoid
sharp bends.
Secure wires to the handlebar with
electrical tape.
Secure any loose wires together.
Wrap bar tape over the wires.
It is ok to wrap bar tape over Blips.
NOTICE
Measure the length of wire required
and select the appropriate Blip wire
length before installing the Blip.
To avoid damage to wires, avoid
sharp bends.
Secure wires to the handlebar with
electrical tape.
Secure any loose wires together.
Wrap bar tape over the wires.
It is ok to wrap bar tape over Blips.