SRAM BlipBox - Blip Wire Specifications and Requirements

19
NOTICE
At least one Blip wire must have a
minimum of 100 mm of uninterupted
exposed wire for proper signal
transmission. Routing wires under
bar tape does not hinder signal
transmission and is acceptable. Before
use, test for proper function.
NOTICE
At least one Blip wire must have a
minimum of 100 mm of uninterupted
exposed wire for proper signal
transmission. Routing wires under
bar tape does not hinder signal
transmission and is acceptable. Before
use, test for proper function.
NOTICE
At least one Blip wire must have a
minimum of 100 mm of uninterupted
exposed wire for proper signal
transmission. Routing wires under
bar tape does not hinder signal
transmission and is acceptable. Before
use, test for proper function.
NOTICE
At least one Blip wire must have a
minimum of 100 mm of uninterupted
exposed wire for proper signal
transmission. Routing wires under
bar tape does not hinder signal
transmission and is acceptable. Before
use, test for proper function.
NOTICE
At least one Blip wire must have a
minimum of 100 mm of uninterupted
exposed wire for proper signal
transmission. Routing wires under
bar tape does not hinder signal
transmission and is acceptable. Before
use, test for proper function.
NOTICE
At least one Blip wire must have a
minimum of 100 mm of uninterupted
exposed wire for proper signal
transmission. Routing wires under
bar tape does not hinder signal
transmission and is acceptable. Before
use, test for proper function.
NOTICE
At least one Blip wire must have a
minimum of 100 mm of uninterupted
exposed wire for proper signal
transmission. Routing wires under
bar tape does not hinder signal
transmission and is acceptable. Before
use, test for proper function.
NOTICE
At least one Blip wire must have a
minimum of 100 mm of uninterupted
exposed wire for proper signal
transmission. Routing wires under
bar tape does not hinder signal
transmission and is acceptable. Before
use, test for proper function.
NOTICE
At least one Blip wire must have a
minimum of 100 mm of uninterupted
exposed wire for proper signal
transmission. Routing wires under
bar tape does not hinder signal
transmission and is acceptable. Before
use, test for proper function.
Blip Wire Blip Wire Blip Wire
Blip Wire Blip Wire Blip Wire
Blip Wire Blip Wire Blip Wire
100 mm
Measure Mesurer Medir
Messen Misurare
計測
Medir Meten
测量