SRAM i-motion 3 User Manual

i-MOTION 3 · June 2006
12
ASSEMBLY HUB
» Spoke the hub as normal.
16
Set the dust cover (1) onto the
driver. The curve must point to
the outside.
17
Set the sprocket (2) onto the
driver.
If an offset sprocket will be used,
mount the sprocket with the curve
pointing to the outside.
18
Mount the sprocket retaining
ring (3) onto the driver. Check
proper seat of the retaining ring.
19
Slide the cable stop bracket (4)
onto the axle end of the
sprocket side. Thereafter mount
the washer with rubber insert (5)
to fix the the cable stop bracket.
» Place the rear wheel into the rear
frame.
ASSEMBLY
OF COMPONENTS
3
1
2
18
17
16
19
4
5

SRAM i-motion 3 Specifications

General

Brand	SRAM
Model	i-motion 3
Category	Bicycle Accessories
Language	English