SRAM Quarq - Page 28

28
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
5. Align the groove on the SLED with the
slot in the receiver.
6. Slide the SLED into the RECEIVER. The
LED will blink to show the connection
status:
Green long flash - good connection to
spindle.
Red long flash - poor connection to
spindle.
2 Red fast flashes every 2 seconds -
power measurement failure.
Install Installer Instalar
Einbauen Installare
取り付け
Instalar Monteren
󲶾󸃔
5 6
Measure Mesurer Medir
Messen Misurare
計測
Medir Meten
󴳖󹄡