6–4 IN CASE OF EMERGENCY
Changing a Wheel
1. Remove the spare wheel from tailgate
with jacking tools.
2. Use the wheel wrench to loosen the
wheel nuts one turn each.
CAUTION
Do not remove any of the nuts until
you have raised that wheel off the
ground.
3. Insert the jack connection rod and the
wheel wrench into the jack.
4. Rotate the jack connection rod clockwise
to raise the lift head slightly.
5. Locate the jack according to the fig.
below.
Jack connection rod
Wheel wrench
Removing the Spare Wheel
The spare wheel is located on the tailgate.
1. Remove the key cylinder while inserting
the key into the key cylinder.
2. Unscrew the nut by rotating the wheel
wrench counterclockwise.
3. Remove the spare wheel carefully.
Getting the Jack Connection Rod
Jack connection rod is located under the rear
seats and covered by carpet.
K140_RHD_EN_06.p65 2004-11-11, ¿ÀÈÄ 4:084
To Next Page
Loading...
Need help?
General
