IN CASE OF EMERGENCY 6–5
(Front) (Rear)
CAUTION
Do not attempt to raise vehicle until
the jack is in the proper position,
and secure both to the vehicle and
the ground.
7. Jack up the vehicle by rotating the jack
connection rod clockwise until the tyre
is off ground about 1 inch (3cm).
8. As the jack begins to raise the vehicle,
make sure jack is properly placed so it
will not slip.
NOTE
Do not raise vehicle more than is
necessary to change wheel.
WARNING
Never get under car or start or run
the engine while car is supported by
a jack.
Vehicle may slip off the jack
resulting in serious injury or death.
6. Place the jack vertically at the front or
rear jacking location closest to the wheel
you plan to change.
9. Remove wheel nuts completely by
turning counterclockwise.
10. Remove tyre and wheel.
11. Mount spare tyre on the wheel hub.
CAUTION
•
Never use oil or grease on wheel
nuts.
•
Always use the correct wheel nuts.
•
Using the wheel nut wrench in the
vehicle tool kit, tighten the nut
down firmly.
•
As soon as possible, take your car
to a Ssangyong dealer or
Ssangyong Authorized Service
Operation and have the wheel
nuts tightend according to
Ssangyong specifications.
•
If tighten inconnectly, the nuts
could come loose.
K140_RHD_EN_06.p65 2004-11-11, ¿ÀÈÄ 4:085
To Next Page
Loading...
Need help?
General
