SERVICE AND MAINTENANCE 7–33
FRONT COMBINATION LAMPS
(TURN SIGNAL LAMPS AND
POSITION LAMPS)
Bulb Replacement:
1. Remove the two screws and the two
nuts.
2. Remove the lamp assembly.
3. Rotate the bulb holder counterclockwise.
4. Pull the bulb holder out of the lamp hous-
ing.
5. Press the bulb inward and rotate it coun-
terclockwise to remove it from the bulb
holder.
CAUTION
Greasy fingers will cause stains, re-
sulting in a dull light.
•
Do not touch halogen bulbs with
bare hands.
•
Clean with a clean non fluffy cloth
using alcohol or white spirits.
HEADLAMPS
Bulb Replacement:
1. Open the hood.
2. Disconnect the wiring harness
connector from the rear of the bulb
by pressing the upper part of the wiring
harness connector.
3. Rotate the headlamp cap
counterclockwise.
4. Remove the headlamp cap.
5. Remove the bulb .
6. Install the proper replacement headlamp
bulb.
7. Reinstall the headlamp cap.
8. Reconnect the wiring harness
connector.
1
2
3
1
2
3
K140_RHD_EN_07.p65 2004-11-11, ¿ÀÈÄ 4:0933
To Next Page
Loading...
Need help?
General
