G
G-P6025-TM001
Issue B
DigiSAFE DiskCrypt M100 User Manual 12
4.2.4 Change Admin PIN
The Admin PIN provides a layer of protection around your DISKCRYPT M100 device to
deter others from unauthorized access of the Administrative functions. It is
recommended that you change the default factory Admin PIN to another one that only
you know. To change your Admin PIN, follow these steps:
1. Insert the smart card into DISKCRYPT M100. The keypad will turn on to allow key
entry.
2. Press the CHANGE PIN button, followed by the ‘0’ button.
3. Press ENTER. The STATUS LED blinks three times.
4. Enter the current 8-digit Admin PIN and press ENTER. The STATUS LED
blinks twice.
5. Enter the new 8-digit Admin PIN and press ENTER. The STATUS LED blinks
twice.
6. Repeat the new 8-digit Admin PIN and press ENTER. While the Admin PIN
change process is taking place, the STATUS LED will continue to blink.
DISKCRYPT M100 will provide three ‘beep’ sounds to indicate that this operation
is successful.
7. Remove and reconnect the USB cable to exit the Administrative mode.
If you have mistyped your PIN, press the ESC button at any time to restart the entire
authentication process.
Note:
Like the smart card user PIN, DISKCRYPT M100 only accepts 8-digit ADMIN PIN. If a
shorter or longer PIN is entered, the ERROR LED will blink continuously. Press the
ESC button to restart the authentication process again. You will need to restart the
entire PIN Change process from step 2.
To Next Page
Loading...