CONTENTS OF KIT
PREPARE THE TRANSMITTER
Motor ESC
Antenna
Receiver
Aileron Servos
Rudder Servo
Elevator Servo
Li-Po Battery
CH3
driving servo RMS
CH 1
CH
2
CH
5
01、Fuselage ……………………….. X1
02、Hatch …………………………… X1
03、Left Wing ………………………..X1
04、Right Wing ………………………X1
05、Stabilizer ………………………..X1
1、Locate the transmitter ；
2、The transmitter requires eight alkaline “AA” batteries. To install the batteries, remove the
battery hatch by sliding it down and inserting them into place(PIC.02). Be sure to follow
the polarity diagram inside the battery compartment. Reinstall the battery hatch(PIC.03).
CAUTION:(1)、Don't use rechargeable batteries (NiCd & NiMh) ;
(2)、Don't mix old and new batteries;
(3)、Don't mix alkaline and standard (carbon-zinc)batteries;
3、Switch the transmitter on and check the LED on the front of the transmitter(PIC.04). If the
green LED is on it is safe to fly.If the red LED is flashing, install fresh batteries. Also
check to make sure that the batteries are installed correctly.
(PIC.01)
06、Screw …………………………… X1
07、Wing Connecter ……………….. X1
08、Transmitter …………………….. X1
09、Battery park ……………………..X1
10、Decals …………………………… X1
11、Product Manual ………………... X1
-2-
03
04
01
05
06
09
07
08
02
To Next Page
Loading...
