st model DG-1000 - Charge the Battery; Assemble the Airplane

-3-
4、We suggests that the Flying mode should be on the
“NORMAL” mode, while the throttle trim will be at min.
5、Switch the transmitter off and stand by for later use.
PIC.01
PIC.03
PIC.02
PIC.04
ASSEMBLE THE AIRPLANE
Tool will be required for assembly as below
Nipper pliers Screw driver Spanner
5.5mm
CHARGE THE BATTERY
Dg1000 is equipped with a 3cell-11.1V Li-Po battery
pack(PIC.05).The Li-Po battery has two connectors. One is
for cell balance charging and the other is for discharging.
CAETION： 、Only charge the Li-Po battery with Li-Po
battery balance charger. Or use a conforming charger
which can ensure the Li-Po battery safety during
charging.
⑵、Before charging, disconnect the battery with
any power. After each flight ,remove the pack from the
airplane and allow it to cool completely before recharging.
3、During the charging process, keep the charger or battery pack in a normal temperature
area and away from source of ignition. Do not cover the charger or battery pack with
carpet, clothe or anything else. Air circulation is necessary for proper cooling.
4、Important: Never leave a charging battery unattended. Please stop charging immediately
of the battery temperature rise rapidly.
⑴
Please choose the proper power, battery and transmitter or it will reduce the longevity
under the incorrect improvements.
Discharging connector
Balance charging Connector
PIC.05