PIC.23
INSTALL THE BATTERY
2、Switch on the transmitter, ensure that the flying mode is on the “NORMAL” mode and
throttle trim is at the min position(PIC.27).
3、Attach the battery connector to the power plug of the fuselage(PIC.28).The RMS will
be unfolded from fuselage(PIC.29) The ESC will respond with one beep.
WARNING: The ESC is now armed and the propeller will turn if the throttle stick is moved,
possibly resulting in damage or injury.
1、Preparation of battery: Stick the loop tape (with the hook tape together) which is inside of
the fuselage, to the battery by the double pastern(PIC.24-26).
Ensure the battery has been charged and has enough power before next step.
PIC.24
PIC.25
PIC.26
4、 Locate the battery inside the battery location as illustration .
NOTICE:⑴、Before connecting the battery, make sure the LED on the transmitter is on.
(PIC.30)
PIC.28 PIC.29
PIC.20
PIC.22
6、Please put the wing connector through the fuselage and
insert to the other wing, and put the aileron servo wire
through the fuselage into the canopy as above step
(PIC.20).
7、Take the aileron servo wires and connect to the servo
extension leads. Ensure the polarity should be contacted
correctly(PIC.21).
8、Fit the wings and the fuselage in place(PIC.22). And
check if the wings installment right or not again Then
tighten the screws under the wings(PIC.23), to avoid the
wings loosening.
-5-
PIC.21
PIC.27
NORMAL
To Next Page
Loading...
