Automatically run the program
and displays the current status:
the coordinate values, count or
program lines
Motor interrupt the current operation,
for deceleration stop, remember the
current coordinate value, then the
program pointer operations into A or B
operation specified by the entrance to
the program.
Power on or Rest
A:After power on or Rest, Coordinates
to reset, As the coordinate zero, In
standby mode;
B: Memory is not cleared, the data
transferred to the last stored
memory(Please refer to the "Program
Edit")
Auto ModeL 000000
This step is step number
display, You can switch
the display mode for the
count or program
Motor run in accordance
with the appropriate amount
of displacement in the
direction and speed of
To Next Page
Loading...
