Need help?Do you have a question about the Stabila LAR-250 and is the answer not in the manual?
General| Type | Rotary Laser Level |
|---|---|
| Self-Leveling | Yes |
| Laser Class | Class 2 |
| Self-Leveling Range | ± 5° |
| Laser Wavelength | 635 nm |
| Range | 250 m |
| Power Source | Battery |
| Battery Life | 30 hours |
| Operating Temperature | -10°C to 50°C |
Automatic levelling with height of tool alert function, indicated by green LED and flashing Y LED.
Compensates for tremors; stops laser if threshold exceeded, Y LED flashes.
Constantly levels to eliminate discrepancies on vibrating surfaces; red LED indicates mode.
Setting laser on side feet for vertical levelling and aligning with reference lines.
Using markings on base to transfer a plumbline from floor to ceiling.
Steps for performing a horizontal calibration check by marking points after 90° rotations.
Specifies acceptable differences between marked points for accurate horizontal calibration.
Procedure to enter adjustment mode and correct horizontal alignment using remote buttons.
Steps for checking vertical calibration between two parallel walls by marking points.
Procedure to enter adjustment mode and correct vertical alignment using remote buttons.
To Next Page
