STACYC 16EDRIVE - Battery Installation; Battery Removal

P a g e | 13
◀
◀
◀
◀
◀
◀
◀
◀
◀
Baery Release
Buon/Latch
◀
◀
BATTERY INSTALLATION:
Note: The cycle should be turned OFF and the baery
removed when unit is not in use. If the power switch is
le on, the baery loses its charge.
1. Locate baery and orient as shown, it is easier if you
turn the handlebars le or right 45 degrees.
2. Slide baery into slot on the front of the down tube
of the cycle.
3. There is a point where the baery release latch/buon provides some resistance.
Push the baery past this point. You should hear a click, and this gap should be
closed.
BATTERY REMOVAL:
1. Turn the handlebar 45 degrees from straight.
2. Depress the baery release latch/buon and slide baery out of slot in the
direcon shown.