EasyManua.ls Logo

STACYC 16EDRIVE - Cycle Handling Procedures; Safe Handling and Transport

STACYC 16EDRIVE
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
P a g e | 19
3. Turn Power Switch to the “ON” posion.
4. Ensure YELLOW LED is lit, indicang “Standard Mode”
selected. If not, see Throle operaon and Changing Power
Mode secons in this manual.
5. Adult should supervise child as the top speed and
acceleraon have both increased in this mode.
6. The child must demonstrate the ability to roll o throle and
use the brake to slow to a stop, and maintain a safe distance
for obstacles and other riders.
• Advanced Mode - This mode is for advanced and older riders only.
1. Turn Power Switch to the “OFF” posion.
2. Install Baery.
3. Turn Power Switch to the “ON” posion.
4. Ensure GREEN LED is lit, indicang “Advanced Mode”
selected. If not, see Throle operaon and Changing Power
Mode secons in this manual.
5. Adult should supervise child as the top speed and
acceleraon are at their maximum in this mode.
6. The child must demonstrate the ability to roll o throle and
use the brake to slow to a stop, and maintain a safe distance
for obstacles and other riders.
SAFELY APPROACHING OR RE-MOUNTING THE CYCLE:
During adult supervision, always teach children to approach the cycle with cau-
on before use, while standing back up if knocked over, or aer a spill.
1. Carefully place the Power Switch into the “OFF” posion.
2. Ensure all wheels/res and drive train components have stopped
rotang or moving.
3. Perform a “Pre-Ride Inspecon” (below)
4. Have rider mount the cycle, gripping the handlebars with both hands,
sing on the saddle with both feet at on the ground.
5. Place the power switch into the “ON” posion.
6. Finally: carefully resume riding your cycle.
LOADING AND UNLOADING A CYCLE INTO A VEHICLE:
1. Place the Power Switch into the “OFF” posion.
2. Remove baery.
3. Load into vehicle for transport.
4. Aer unloading, ensure Power Switch is in “OFF” posion.
5. Install baery.
6. Perform Pre-Ride Inspecon.
FAILURE TO USE COMMON SENSE AND HEED THE ABOVE WARNINGS
INCREASES RISK OF SERIOUS INJURY. USE WITH APPROPRIATE CAUTION AND
SERIOUS ATTENTION TO SAFE OPERATION.

Related product manuals