STACYC Stability Cycle - Hardware and Loose Parts Check; Safety Gear and Laws; Charging the Battery; Battery Installation and Removal

P a g e | 18P a g e | 18 DOC 001 REV A DOC 001 REV A P a g e | 19
REPAIR AND MAINTENANCE:
Tools Req’d:
• 2.5, 4, 5, 6 mm Allen Wrench
• 8, 10, 15 mm socket or open end/box end wrench
• T-10 Torx driver
Turn power switch to “OFF” posion, remove baery, allow STACYC Stability Cycle
to cool before beginning repair or maintenance:
• Read instrucons.
• Ensure the power switch is “OFF”.
• Ensure the baery is removed and STACYC stability cycle has had adequate me to
cool. (up to 30 minutes)
• Secure the STACYC stability cycle for repair or maintenance.
• Exercise cauon around exposed parts.
• Contact STACYC customer service if unsure about any repair or maintenance.
Replacement Parts:
For the complete selecon of replacement parts visit www.STACYCstabilitycycle.com
Repair Centers:
For a list of authorized STACYC service centers, check Online at:
www.STACYCstabilitycycle.com
Test Brake:
1. Squeeze brake lever and hold.
2. Push stability cycle forward. The rear wheel should not spin if brake is adjusted
properly.
3. If rear wheel spins when pushed forward or brake lever engages prematurely,
refer to “Adjust Brake”.
Adjust Brake:
1. To adjust brake cable:
a. Twist brake lever adjuster in or out, 1/4 to 1/2 turn at a me, unl
desired brake adjustment is aained.
b. If brake sll needs further adjustment, proceed to step 2.
2. Determine if brake cable has too much slack or brake rotor is dragging on
brake pad:
a. Loosen brake hub barrel adjuster.
b. Adjust brake hub adjuster in or out unl desired brake adjustment
is aained.
c. Lock brake hub barrel adjuster.
d. Perform nal adjustment of tension in brake cable with brake lever
barrel adjuster.
e. Repeat “Test Brake” secon above.
WARNING: Careful adjustment of brake is crical as the brake is capable of causing
the stability cycle to skid the re throwing an unsuspecng rider. Test and pracce
braking in an open area free from obstacles, in a straight line, unl child is familiar
with the brake funcon. Avoid skidding to a stop as this can cause child to lose con-
trol or damage the rear re.
WARNING: Motor and Electronic Speed Controller (ESC) can be very hot and cause
burns. It is crical that the STACYC Stability Cycle is allowed to cool prior to access-
ing motor and ESC!
WARNING: To prevent shock, please follow the instrucons accordingly and do not
skip any steps.
Replace Fuse:
1. Place power switch in “OFF” posion.
2. Remove baery from stability cycle.
3. Remove foot rest.
4. Remove right side panel, allow motor and ESC adequate me to cool before you
proceed.
5. Locate fuse. Remove the fuse from socket. Verify that replacement fuse is the
specied amperage. Replace fuse.
6. Re-Install right side panel.
7. Install the footrest.
Brake Lever barrel adjuster
Brake Hub barrel adjuster
◀
◀
Fuse located inside of down tube
◀