STACYC Stability Cycle - Led Information; Error Codes

P a g e | 16P a g e | 16 DOC 001 REV A DOC 001 REV A P a g e | 17
LED INFORMATION
ERROR CODES
PROGRAMMING MODE ACTIVATION: only to be activated by an adult
POWER
SWITCH
POWER
SWITCH
POWER
SWITCH
THROTTLE
POSITION
THROTTLE
POSITION
THROTTLE
POSITION
SITUATION/ REACTION
SITUATION/ REACTION
NOTES:
LED
LED
LED
ILLUMINATION
ON
ON
OFF
ON ON ON ON ON ON ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ZERO
ZERO TO
FULL
Hold at
FULL
Hold at
FULL
Hold at
FULL
Hold at
FULL +1sec
Release
to ZERO
Release
to ZERO
ZERO
Turn throle
-lights will light up as throle moves
from ZERO to FULL
ZERO TO
FULL
ZERO
ZERO
ZERO
5-10%
5-10%
5-10%
10%-FULL
10%-FULL
10%-FULL
NONE
Flashing
YELLOW
NONE
YELLOW
ashing (5xs)
G,Y,R Flashing +
Beeping (5xs)
NONE NONE
Select power level and hold
throle unl you hear 2 short
beeps
R, Y, G lights ash and 1 long
beep is heard
“SELECTED POWER MODE, LED
WILL ILLUMINATE”
IF ANY LIGHTS REMAIN ILLUMINATED WHEN THROTTLE IS
RETURNED TO ZERO, PROGRAM MODE IS NOT ACTIVATED
AND BIKE WILL MOVE WHEN TURNING THE THROTTLE.
EXERCISE CAUTION!
GREEN=ADVANCED/HIGH POWER
YELLOW=STANDARD/MEDIUM POWER
RED=TRAINING/LOW POWER
STACYC is turned OFF
Flashing
RED
RED
YELLOW
GREEN
G,Y,R
Y, R
R
G,Y,R
Y, R
R
bike could be in program mode(exercise cauon with the
throle)
ESC overload error, reset by turning POWER SWITCH
“OFF”, then back “ON”
Temperature error, reset by turning POWER SWITCH
“OFF, then back “ON”. Change riding condions and
ride on at ground to cool down STACYC.
bike powered on and in “TRAINING/LOW”
power mode
bike powered on and in “NORMAL/MED”
power mode
bike powered on and in “ADVANCED/MED”
power mode
bike powered on and showing FULL
baery charge
bike powered on and showing MEDIUM
baery charge
bike powered on and showing LOW
baery charge
motor will engage & drive bike at selected power mode,
FULL baery charge
motor will engage & drive bike at selected power mode,
MED baery charge
motor will engage & drive bike at selected power mode,
LOW baery charge