STACYC Stability Cycle - Charging the Battery; Battery Removal; Battery Installation

P a g e | 10P a g e | 10 DOC 001 REV A DOC 001 REV A P a g e | 11
Hardware/Loose Parts: Check all hardware, such as nuts, bolts, cables, fasteners, etc. to
ensure they are secure. There should not be any unusual rales or sounds from loose parts or
broken components. If the unit is damaged, do not ride it. Reference “Warnings” listed in this
manual.
Safety Gear: Check that proper protecve gear, such as an approved and properly ed safety
helmet, eye-wear, athlec shoes (Closed toe shoes with rubber soles), elbow pads, kneepads,
etc., are in place prior to riding. Keep shoelaces ed and out of the way of the wheels, motor
and drive system. NEVER RIDE BAREFOOTED OR IN SANDALS.
Laws and Regulaons: Check and obey any local laws or regulaons prior to riding.
Insurance: Verify with your insurance company that your exisng insurance policies provide
necessary coverage for stability cycle use.
CHARGING THE BATTERY:
Remove baery from stability cycle and place on charger. Refer to instrucons pro-
vided by baery and charger manufacturer. The stability cycle should be turned OFF
and the baery removed when unit is not in use. If the power switch is le on, the
baery loses its charge.
BATTERY:
Note: The stability cycle should be turned OFF and the baery removed when unit is
not in use. If the power switch is le on, the baery loses its charge.
BATTERY INSTALLATION:
Note: The stability cycle should be turned OFF and the baery removed when unit is
not in use. If the power switch is le on, the baery loses its charge.
◀
◀
◀
◀
Baery Terminal
Locaon
Baery Informaon
Label
Baery Release
Buon/Latch
1. Locate baery and orient as shown,
it is easier if you turn the handlebars
le or right 45 degrees.
2. Slide baery into slot on the front of
the down tube of the STACYC.
3. There is a point where the baery release latch/buon provides some
resistance. Push the baery past this point.
• You should hear a click, and this gap should be closed.
BATTERY REMOVAL:
1. Turn the handlebar 45 degrees from straight.
2. Depress the baery release latch/buon and slide baery out of slot in the direc-
on shown.
◀
◀
◀
◀
◀
◀
◀
◀
◀
Baery Release
Buon/Latch
◀
◀