SAFETY INSTRUCTIONS
Please read the
instructions
carefully as they include important
information about the installation, operation and maintenance.
•
Please
keep this user’s guide for future
consultation.
If you
sell
the unit to another
user, be sure that they also
receive
this
instruction
booklet.
•
All fixtures leave
the
manufacturer
intact.
Please
note that any
damages
incurred
by the user is not covered by the guarantee.
•
Unpack and check
carefully
that there is no
transportation
damage before using
the unit.
•
The
unit is for indoor use only. Use only in a dry location.
•
Use a
safety
bond when
attaching
the
fixture
to a
lighting
rig.
Handle
by the
hanging
bracket when fixing.
•
The
unit must be
installed
in a location with
adequate ventilation
at
least
50 cm
from
adjacent
surfaces.
•
Make sure that no
ventilation
slot is blocked,
otherwise
the unit will overheat.
•
Before operating, ensure
that the
voltage
and
frequency
of the power supply
match the power
requirements
of the unit.
•
Make sure
all equipment
is
properly
earthed.
•
Do not operate the unit if the ambient
temperature
is
higher
than 40°C.
•
Do not
hardwire
to any
mains
dimmer.
•
On the first start, there may be some
normal operational
start-up smell.
•
Make sure that there is no
flammable material
close to the unit
while operating,
as
it is a
fire
hazard.
•
Look over power wires
carefully
and
replace immediately
if there is any damage.
•
Never
run on for a long time lest
shortening lifespan. Avoid
any inflammable
liquids,
water or metal objects
entering
the unit. In case it
happens,
cut off the
mains
power immediately.
•
Do not operate in a dirty or dusty
environment. Clean fixtures
regularly.
To Next Page
Loading...
