Stagg MPAS 80/10 - Page 5

5
User’s manUal
mPas 80/10 & mPas 80/12
How to operate the MPAS 80/10 or MPAS 80/12
1 - LINK OUTPUT - This 1/4’’ jack socket features a line level output w/ 1k Ohm impedance@-10dBV
It is used to connect the MPAS 80/10 or 12 to an additional power amplier, to another powered speaker
or to a recording system. This line level signal source is the same as the one at input 3 .
2 - MIC Input - This low impedance (1 k Ohm, typical) XLR input socket is designed to connect low
impedance microphones with balanced output Wiring of the 3-pin connector is: Pin 1= Shield; Pin 2 =
Positive (Hot); Pin 3 + Negative ( Cold)
3 - LINE Input - This 1/4” input jack features a high impedance (100k Ohm, typical) to connect high
impedance microphones or devices with a line level output, such as: Tape/CD/Radio players/Effect gears
(Return Loop), etc An Electric/Bass guitar or a keyboard can also be plugged in
Both the high and the low impedance inputs may be used simultaneously
4 - MIC/LINE Volume - Controls the overall listening volume of the MIC/LINE mix
5 - HIGH - Adjusts the high-end frequency level of the EQ in the tone section
6 - MIDDLE - Adjusts the mid-end frequency level of the EQ in the tone section
7 - LOW - Adjusts the low-end frequency level of the EQ in the tone section
8 - AUXILARY Volume - This Control adjusts the level of the playback inputs: RCA/Phono/Cinch sockets
on the control panel, see 9
9 - AUXILARY IN - These RCA/Phono (RCA/Cinch) sockets are provided for connecting external sound
sources such as: CD/MD/Tape machines Left and Right inputs are linked together for monophonic use
10 - POST EQ - Both RCA/Phono (RCA/Cinch) sockets deliver a line-level, post EQ, output signal for
recording use The output level depends on tone section
11 - PRE EQ - This 1/4’’ jack socket is an external output for use with an extra EQ, an active Sub
Woofer, etc It provides a combination of all input signals and controls but is not inuenced by the tone
section The impedance is 2k Ohm
12 - EXT. SPEAKER - This 1/4’’ jack socket is an external, 8 Ohm impedance output for use with
passive enclosures only (Extension Speaker Cabinets, Sub Woofers, etc) featuring a minimum load
impedance of 8 Ohm
This output provides a combination of all input signals and controls and is inuenced by the tone
section.
13 - POWER - This ON/OFF switch activates/deactivates the unit Red LED «ON» means
the equipment is ready to work
When the mains switch is in position «1», the power is switched «ON»
When the mains switch is in position «0», the power is switched «OFF»
14 - MAINS SOCKET - Plug mains cable into this socket prior to connect it to the proper
power outlet. This socket also features the (T1A) Mains Fuse.
Features and Specications are subject to change without notice