7
USER MANUALPA4/200 & PA4/200 DSP
INSTRUCTIONS FOR USE:
First check the available mains voltage (120VAC or 230 VAC). If necessary, change power voltage on your
device with the Voltage Selector (see n°4, page 5). Plug the mains lead into a suitable power socket (see
n°2, page 5). Connect your speaker cabinets a to the output speaker sockets at the rear panel (see n°8,
page 5) with the 10-meter speaker cables supplied. Make sure that the master volume is set to zero before
powering on the amplier to avoid possible damage to the speakers. Finally, set the MASTER volume to
zero and push the Power Switch to the ON position. The power switch will light up and your PA system is
ready for use. Should you experience any feedback coming from the speakers, rst diminish the volume of
each channel in use in order to nd & suppress the microphone causing the feedback. Then reposition this
microphone, preferably somewhere behind the speakers, and reset the channel volume accordingly.
IMPORTANT SAFETY INSTRUCTIONS:
READ AND KEEP THESE INSTRUCTIONS. HEED ALL WARNING.
• If, after you have followed the instructions outlined above, the powered mixer fails to function, please contact
your vendor. Under no circumstances should the unit be opened. Leave servicing to qualied personnel only.
• Electrical appliances must never be used in conditions of high humidity or heat.
To prevent any risk of electric shock or re, never spill or splash liquids on the unit.
Should this happen, unplug the power cable from the mains outlet immediately.
• Your attention is drawn to the instructions printed on the notice attached to the back of the unit.
• Exposure to extremely high noise levels may cause permanent damage to hearing. Use this apparatus
responsibly for you and your neighbourhood.
MARKING & CONFORMITY:
1. The CE mark on this product means it conforms to the EMC Directive (89/69/EEC), CE marking Directive
(93/68/EEC) and Low Voltage Directive (72/23/EEC).
2. The «Crossed-out Wheeled Bin» is to draw your attention on the WEEE (Waste Electric & Electronic
Equipment) Directive (2002/96/EC). It means this apparatus must be collected separately for recycling.
3. «RoHS compliant» means this device conforms to the Directive (2002/95EC) on the restriction of the
use of certain hazardous substances in electrical and electronic equipments, such as: Mercury, Lead,
Cadmium, Hexavalent Chromium, Polybrominated Buphenyl (PBB) and Polybrominated Diphenyl Esthers
(PBDE).
RoHS
compliant
To Next Page
Loading...
