9
1. Mic XLR Input
Plug a mic directly into this port for public address usage and let your voice be heard.
2. 1/4” MIC Input
Plug a mic directly into this port.
3. RCA Line Input
This connection is designed to accept a line input signal from a mixer or other
line level device. Be sure to connect only line level input devices such as mixers and tape
machines to this jack.
4. Balanced XLR Li ne Input
This connection is designed to accept a balanced line input signal from a mixer or other line
level device with a balanced output. Use a balanced cable when the signal cable length
exceeds 15 feet/4,5m , this will reduce excessive signal loss.
5. 1/4” Line Output Jack
This jack is used to send the mixed incoming signals to another powered speaker.
6. XLR LINE Output
Using a XLR cable, use this port to daisy chain this speaker to another powered speaker.
7. Main Power Inlet
This connector is used to supply main power to the unit via the included detachable
power cord.
8. Fuse Holder
This housing stores the 3.15 amp GMA for 230v and 5 amp GMA for 110v protective fuse.
Always replace with the exact same type of fuse.
9. Microphone input Volume
This knob is used to increase or decrease the volume of your microphone.
10. Line level input volume
This knob is used to regulate the volume of source connected to the Line Level Inputs.
11. output volume
This knob is used to regulate the the volume of the output and the volume of the signal being
sent to another powered speaker.
12. Treble control
This knob is used to regulate the amount treble applied to the output signal.
The maximum amount of treble gain is +12dB and the maximum amount of treble decrease
is -12dB. Turning the knob in a counter-clockwise direction will decrease the amount of treble
applied to a channel signal, turning the knob in a clockwise direction will increase the amount
of treble applied to a channel signal.
13. Bass Control
This knob is used to regulate the amount bass applied to the output signal.
The maximum amount of bass gain is +12dB and the maximum amount of bass decrease
is -12dB. Turning the knob in a counter-clockwise direction will decrease the amount of bass
applied to a channel signal, turning the knob in a clockwise direction will increase the
amount of bass applied to a channel signal.
14. Power indica tor led
LED lights up to indicate the speaker is on.
15. Clip Led
If this LED is lit it means your signal is clipping. To stop the signal from clipping lower the
volume to the point where the LED is blinking along with the bass beat.
16. On/OFF switch
To Next Page
Loading...
