Istruzioni Instructions Anleitungen Instructions instrucciones
10
WARNING !
• This instruction handbook is for qualified staff only and not for final users; nevertheless the
installer must teach the user how to use the automation, inform them about possible
dangers and the importance of a regular maintenance.
• The installation has to be carried out by qualified staff only and in compliance with the
latest safety regulations in the automatic opening sector; particularly the installation has
to comply with the 89/392 directive and the EN 12453 and EN12445 regulation.
• ICARUS has been developed for the automation of sectional and spring and
counterweight overhead doors. The use of the product for unsuited purposes is strongly
forbidden.
• Use only original spare parts. Stagnoli does not take upon any responsibility for damages
caused by the inappropriate use of non-original components.
• Make sure that the garage ceiling and walls are strong and stable, please pay attention
to install the operator in a bump free area.
• Make sure that the garage door frame is solid and suitable to be motor driven.
• Make sure that the door is friction free.
• The door must be properly balanced.
• Before and during installing make sure that the power supply is off.
• Choose the safety devices to be installed very carefully, moreover do not forget to add
an emergency stop device to cut off the power supply.
• Connect the power supply cable only to adequately protected plugs; please install a
device for the disconnection of every single pole from the electric network by leaving a
space of at least 3.5 mm between each contact.
• In case of a sectional or overhead garage door with built-in side door, the automation
must stop when opening the side door (for ex. install a micro-switch in the side door
frame and connect it to the Stop input on the control board).
• The irreversible gearmotor avoids installing an electric lock and in case of black-out the
release allows the gate to be easily opened and closed.