EN
- 38 -
Remove the lters, making sure no fatty deposits and left-over food falls into the openings under the lters.
Clean the lters of food residue and sediment and then rinse thoroughly. Do not use sharp tools or sharp
edges to clean the lters. Make sure to also remove limescale, as this prevents the build-up of a layer on the
surface of the lter.
The surfaces of the lters should be cleaned thoroughly with a damp cloth and neutral (non- aggressive)
detergents with no chlorine content and agents that do not cause corrosion and mechanical damage to
stainless steel surfaces.
In order to prevent the formation of corrosion spots on the stainless steel, avoid using harsh detergents
containing chlorine and agents that cause corrosion or mechanical damage to the stainless steel surfaces.
For cleaning oors and immediate surroundings, only use detergents that do not cause damage to stainless
steel.
Once a month you should:
• make sure the power cord is not damaged;
• make sure that all components of the appliance are working properly,
• remove the washing arms (Fig. 11) (bottom and top 1 and 2) by loosening the screw (3) and clean under
the current water
Fig. 11
• Clean the outside of the appliance using a washing liquid for stainless steel and a damp cloth and then
thoroughly rinse and wipe dry.
Service the appliance at least once a year to verify its correct operation, determine the degree of wear, de-
tect possible failures of components and parts. If you detect any damage, it should be removed by qualied
technical personnel (technical services). Technical service should pay particular attention to:
• the condition of heating elements,
• the condition of electrical installation,
• the condition of heating elements’ safeguards,
• wear and tear of the appliance,
Any damage or failure resulting from the user’s non-compliance with this manual as well as failure to com-
ply with existing legislation and standards will not be considered manufacturer’s liability.
Downtime in operation
When not expecting to use the appliance for an extended period of time, it is necessary to empty conta-
iners for the washing liquid and rinse aid in order to prevent crystallization and, consequently, damage to
the pump. Accordingly, suction tubes should be removed from both containers and placed in a bowl lled
with clear water; carry out several wash cycles and then drain the tank of water. Finally, turn o the main
switch and close the water tap. Suction tubes must be connected back to the containers only when the
appliance goes back into use (the clear tube goes into the washing liquid container, and the blue one into
the rinse aid container).
It is forbidden to leave the appliance on and the water valve open for an extended period of downti-
me.
In winter period, the device must be stored in a heated room. Otherwise, make sure that no uids have
remained in the device (e.g. boiler, detergent pipes).
To Next Page
Loading...
