EN
- 37 -
7. PROBLEMS, CAUSES, SOLUTIONS
Note: if the steps in the table below, aimed to remove the fault, did not produce the desired result, contact
your service (qualied technical personnel).
PROBLEM CAUSE SOLUTION
The device does not
run
Appliance door does not close Opening and re-closing the door
Burnt fuse Replacing the fuse (call for service)
Improper connection to the power grid Check the electrical connection
Excessive washing
duration
The temperature of the washing water is not
right
Setting a suitable temperature
Abnormal level of water in the appliance Clean the water inlet lter
The appliance does
not wash dishes
Broken washing pump Call for service
Low pump pressure Clean the pump lter
Water temperature is too low Correct the water heating time
Wrong detergent Contact manufacturer
Arms covered with limescale or foreign
bodies present
Clean the arms and remove foreign
bodies
Empty detergent container Rell container
Malfunction in the water treatment unit Notify service
Stains on the forks,
glasses and dishes
Improper arrangement of utensils
Arrange utensils in accordance with
instructions
The temperature of the rinsing water is too
high
Setting a suitable temperature
Incorrect water pressure Clean lters
Water hardness too high Check water hardness
Cleaning agent did not work due to the dirty
water in the machine
Change water in the appliance
Dishes drying improperly Change water in the appliance
Wrong rinse aid Contact manufacturer
Dishwasher does not
rinse
Dirty water inlet lter Clean the lter
Low water pressure
Clean the pump lter and solenoid
valve
Faulty rinsing pump Call for service
Solenoid valve
leaking
Contamination of the solenoid valve
Call for service Note: When installing
the appliance, foreign material or
undesirable chemicals from the wa-
ter supply could have been trapped
in the solenoid valve.
The water pressure
in the appliance is
too low
Contaminated water inlet lter or solenoid
valve
Clean the water inlet lter or soleno-
id valve
Low water pressure in the water supply Contact a plumber
The pump does not
pump out water
Pump clogged
Contact service
Faulty pump
8. MAINTENANCE
Before starting any maintenance work, disconnect the appliance from the power supply.
Daily maintenance involves removing objects from the chamber and washing them with a cloth dampened
in water with a dish detergent and then wiping them o with a dry cloth. Washing under running water as
well as using a pressure washer for this purpose is prohibited.
In the case of intense use, we recommend that you clean the lters every 30-40 wash cycles in order to
ensure the proper functioning of the appliance. To do this, partially drain the tank of water.
To Next Page
Loading...
