1. To store the 1310 Magnetic Upright Exercise Bike, simply keep it in a clean dry place.
2. The minimum rest dimensions of the 1310 Magnetic Upright Exercise Bike are approximately 33.8
inches long x 19.8 inches wide x 48 inches tall. These dimensions will vary. Please measure your
1310 Magnetic Upright Exercise Bike if exact dimensions are needed.
3. To move the 1310 Magnetic Upright Exercise Bike, grasp on the HANDLEBAR(6) and tip the 1310
Magnetic Upright Exercise Bike forward to use the wheels on the FRONT STABILIZER(2).
4. To avoid damage to the meter, remove the batteries before storing the 1310 Magnetic Upright
Exercise Bike for one year or more.
The safety and integrity designed into the 1310 Magnetic Upright Exercise Bike can only be maintained
when the 1310 Magnetic Upright Exercise Bike is regularly examined for damage and wear. Special
attention should be given to the following:
1. Adjust the TENSION KNOB(28) and verify that it functions properly and the resistance changes.
2. Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that
the left pedal has left hand threads and is tightened by turning counterclockwise.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the WARNING LABEL(64) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement WARNING LABEL(64) if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately or the 1310 Magnetic Upright
Exercise Bike removed from service until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the 1310 Magnetic
Upright Exercise Bike.
8. Keep your 1310 Magnetic Upright Exercise Bike clean by wiping it o with an absorbent cloth after
use.
STORAGE
MAINTENANCE
14
OPERATIONAL INSTRUCTIONS
AA Batteries
HOW TO INSTALL AND REPLACE BATTERIES:
1. Open the Battery Door on the back of the meter.
2. The meter operates with two AA batteries, the batteries are not
included. Refer to the illustration to install or replace the batteries.
1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
3. Rechargeable batteries are not recommended.
4. Ultimate disposal of battery should be handled according to
all state and federal laws and regulations.
5. Do not dispose of batteries in re.
NOTE:
To Next Page
Loading...
