Stamina DT Plus Rower - MAINTENANCE

21
1. To store the
Stamina® DT Plus Rower , simply keep it in a clean dry place.
2. Move the
Stamina® DT Plus Rower
with the WHEELS(51) on the FRONT STABILIZER(3). Lift
the Rear Stabilizer on the REAR STAND(2) to move the
Stamina® DT Plus Rower . Do not use
the SEAT(45) to move the
Stamina® DT Plus Rower . The SEAT(45) will move and the SEAT
CARRIAGE(10) may pinch your hand or ngers.
3. To avoid damage to the meter, remove the batteries before storing the Stamina® DT Plus Rower
for
one year or more.
4. Refer to the illustration below. You can stand the
Stamina® DT Plus Rower on end for storage.
The safety and integrity designed into the
Stamina® DT Plus Rower
can only be maintained when the
Stamina® DT Plus Rower
is regularly examined for damage and wear. Special attention should be given
to the following:
MAINTENANCE
STORAGE
1. Pull on the HANDLEBAR(13) and verify that the Fan and Magnetic System provides tension and the
seat travel is smooth and stable.
2. Clean the roller tracks in the RAIL(34) with an absorbent cloth.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Check the condition of the STRAP(50). Replace the STRAP(50) if it is cracked or broken.
5. Verify that the CAUTION LABEL(35) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(35) if it is missing or damaged.
6. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
7. Worn or damaged components must be replaced immediately or the
Stamina® DT Plus Rower
removed from service until repair is made.
8. Only Stamina Products supplied components should be used to maintain/repair the
Stamina® DT
Plus Rower .
9. Keep your Stamina® DT Plus Rower clean by wiping it o󰀨 with an absorbent cloth after use.