SET UP INSTRUCTIONS
Place the INSTRIDE stepper in the area where it will be used. It is recommended that the INSTRIDE
stepper be placed on an equipment mat. The max. operation dimensions of INSTRIDE stepper. is
approximately 17 3/8" long x 11 3/4" tall x 12 3/8" wide. (These dimensions may vary up to one inch.) An
area 4 feet wide x 4 feet long is required for safe operation of the INSTRIDE
stepper. Make sure that
adequate space is available for access to and passage around the INSTRIDE
stepper.
Make sure the INSTRIDE
stepper is set solidly on the floor with no rocking.
Grasp the Front and Rear Stabilizers to move the INSTRIDE
stepper. Do not use the Pedal
Arms to move the INSTRIDE
stepper. The Pedal Arms will move and the SHOCK(6) may
pinch your hand or fingers.
LEVELING:
MOVING:
FUNCTION INSPECTION
NOTE: Always make sure that the CABLE(9) is
properly seated in the groove on the PULLEY(8) before
using the INSTRIDE
stepper.
6
Verify that the SHOCKS(6) provides resistance by pushing down on the foot pedals.
SHOCKS(6) on steppers get HOT during use. To avoid burns, do not touch the SHOCKS(6) until they
have time to cool.
Verify that the Warning Label is in place and easy to read. Call Stamina Products immediately
(1-800-375-7520) for a replacement Warning Label if the Warning Label is missing or damaged.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the INSTRIDE
stepper removed from
service until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the INSTRIDE
stepper.
Keep your INSTRIDE
stepper clean by wiping with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.
The safety and integrity designed into the INSTRIDE
stepper can only be maintained when the INSTRIDE
stepper is regularly examined for damage and wear. Special attention should be given to the following:
MAINTENANCE
STORAGE
1.
2.
3.
4.
To store the INSTRIDE stepper simply keep it in a clean dry place.
The minimum dimesions of INSTRIDE
stepper is approximately 17 3/8" long x 8 1/4" tall x 12 3/8" wide.
These dimensions will vary. Please measure your INSTRIDE
stepper if exact dimensions are needed.
Grasp the Front and Rear Frame to move the INSTRIDE
stepper. Do not use the Pedal Arms to move
the INSTRIDE
stepper.
To avoid damage to the electronics, remove the battery before storing the INSTRIDE
stepper for one
year or more.
Visually inspect the INSTRIDE
stepper to verify that
assembly is as shown in the illustration. Check the
function of the INSTRIDE
stepper. Stand on the foot
pedals and slowly move your highest foot downward
and follow the natural path of the machine. The Shocks
should provides resistance for your workout.
To Next Page
Loading...
