L54 – Manual
WAM454A 6 Standby AB – standbygroup.se
Factory Reset
Introduction
The settings can be changed back to the factory settings.
The factory settings are the following:
Flash pattern – Double
Sync mode - Simultaneous
Reset to Factory Settings
WARNING
Risk of eye damage. Do not look into the beam at close range.
Note
All current settings, that is both flash pattern setting and sync mode setting, are reset to the
default settings.
1. If already in configuration mode, go to step 6.
2. If the lamp is connected to the power supply, disconnect it.
3. Connect the red wire to 10-30 V DC via a 5 A fuse.
4. Connect the black wire to ground.
!
!
To Next Page
Loading...
