L54 – Manual
WAM454A 7 Standby AB – standbygroup.se
5. Within 1 to 6 sec: temporarily connect the white wire to ground and let it stay connected for at
least 2 sec.
The lamp enters configuration mode and a flash sequence indicating the current settings starts.
Note
If this step is performed incorrectly, you must restart from step 2.
6. Connect the BLUE and the WHITE wire to ground and let them stay connected for at least 2
seconds.
7. The reset is confirmed with a bright steady light for 2-3 seconds.
!
To Next Page
Loading...
