Stanley 76001 - Page 13

12
ENGLISH
FITTING THE PIN TAIL DEFLECTOR KIT
IMPORTANT - READ THE SAFETY WARNINGS LISTED IN THE PROSET XT1 AND PROSET XT2 INSTRUCTION
MANUAL CAREFULLY BEFORE PUTTING INTO SERVICE.
IMPORTANT - THE AIR SUPPLY MUST BE TURNED OFF OR DISCONNECTED BEFORE FITTING OR
REMOVING THE PIN TAIL DEFLECTOR KIT.
Refer to  g. 12 and the table 4 on page 9. Refer also to the ProSet XT1 and ProSet XT2 Service Manuals.
Item numbers in bold refer to  g. 12 and table 5, 6.
• The air supply must be disconnected.
• Install Ejector Assembly (TRM00494) and Return Spring (TP144-082).
• Screw End Cap (TP153-112) together with O-Ring (TP154-110), Ejector Guide (TP144-063).
• Fit Collector Adaptor (TP153-111) together with MCS Valve Pusher (TP144-142).
• Place Collector Adaptor Cover (TRM00033) over Collector Adaptor (TP153-111) and then install De ector
Adaptor (TRM00492) until the end face of Collector Adapter Cover (TRM00033) is secure against the
mating face of Collector Adapter (TP153-111).
• Fit De ector (PRG510-56) to De ector Adaptor (TRM00492).
Table 5 - TRM00305 - DEFLECTOR KIT for XT1
Item Part Number Description Qty
1 TRM00033 Collector Adaptor Cover 1
2 TRM00492 De ector Adaptor Assembly 1
3 PRG510-56 De ector 1
4 TRM00493 Ejector Assembly 1
Table 6 - TRM00306 - DEFLECTOR KIT for XT2
Item Part Number Description Qty
1 TRM00033 Collector Adaptor Cover 1
2 TRM00492 De ector Adaptor Assembly 1
3 PRG510-56 De ector 1
4 TRM00494 Ejector Assembly 1