-4-
TOOL SPECIFICATIONS
All screws and nuts are American National Standard.
FASTENER SPECIFICATIONS:
See product illustration #IP1200-1 or BOSTITCH Industrial Tool and Fastener Catalog.
TOOL AIR FITTING:
This tool uses a free-flow connector plug, 1/4” N.P.T. The minimum inside diameter should be .200” (5mm).
The fitting must be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
70 to 90 p.s.i. ( 4.9 to 6.2 kg/cm
2
). Select the operating pressure within this range for best fastener
performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE OF 90 P.S.I.
AIR CONSUMPTION:
The HARTCO C SERIES tools require 2.6 cubic feet per minute ( .07 cubic meters ) of free air to operate at
the rate of 100 clips per minute, at 90 p.s.i. ( 6.2 kg/cm
2
). Take the actual rate at which the tool will be run to
determine the amount of air required. For instance, if your fastener usage averages 50 clips per minute, you
need 50% of the tool's c.f.m. of free air which is required for running at 100 clips per minute.
TOOL OPERATION
EYE PROTECTION
which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
tool. Eye protection is required to guard against flying fasteners and debris, which could
cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
BEFORE HANDLING OR OPERATING THIS TOOL:
I. READ AND UNDERSTAND THE WARNINGS CONTAINED IN THIS MANUAL.
II. REFER TO “TOOL SPECIFICATIONS” IN THIS MANUAL TO IDENTIFY THE
OPERATING SYSTEM ON YOUR TOOL.
MODEL LENGTH HEIGHT WIDTH WEIGHT
C Series Tool 18.5” (470mm) 8” (203mm) 3.75” (95mm) 5.20 lbs (2.50 kg)
To Next Page
Loading...
Need help?
General
